Procces To Make Batik

The technique of batik is a demanding one. In general, the final design must be conceived before the picture is begun. The batik artist works intimately with color; if he wishes parts of his design to be light yellow, for example, all these parts must be waxed at the same time before any subsequent dyeing. He cannot isolate one part of his design and complete it before moving on to the others as an artist in oils or watercolor may; he must create his design in stages, each of which encompasses the whole picture.

The basic process of batik is simple. It consists of permeating an area of fabric with hot wax so that the wax resists the penetration of dye.

If the cloth we begin with is white, such as bleached cotton, linen, or silk, then wherever we apply hot wax that area will remain white in the final design. After the first waxing the fabric is dipped into a dye bath whose color is the lightest tone of those to be used. When the piece has dried, we see an area of white and an area of cloth that is the color of the first dyeing. Wax is now applied to those parts in which we wish to retain the first color, and the entire fabric is immersed in the second dye bath whose color is darker in tone than the first. This process is repeated until the darkest tone required in the final design has been achieved. When the fabric, now almost wholly waxed, has dried it is placed between sheets of absorbent paper and a hot iron applied. As the sheets of paper absorb the wax they are replaced by fresh sheets until the wax is removed. At this point the final design is seen clearly for the first time.